DESS Post Interface (p/n 529 036 019)

[Natali]

DESS Post Interface (p/n 529 036 019)  intended for diagnose all range of 2-stroke vehicles (carb/EFI/RFI/DI) and programing DESS keys for 2-stroke and 4-stroke (4-TEC) vehicles.

Works in conjunction with the MPI-2 interface (p/n 529 036 018) MPI-3 adapter (p/n 529036353)

Is powered by 2 AA size batteries.

The necessity of using DESS Post Interface for diagnostics of the vehicle or programming DESS keys can be determined from B.U.D.S. Chart.

Hardware

DESS Post Interface includes 2 communication built-in cables and one power jack located on the right side of the box.  On top, there is a DESS® key housing and one status LED.

The following table lists the DESS Post Interface hardware components:

 

Component	Description
Built-in cable with DB9 connector (female)	Connects the DESS Post Interface to MPI-2 /MPI-3 Interface.
Built-in cable with a DT-06 connector (male)	Connects to vehicle diagnostic connector or to the DESS adapter (p/n 529 035 904).
Power jack	Connects 12 volts for the diagnosis of 2-stroke models. It is very important to observe polarity! “+” is connected to a central contact. It is strongly recommended to use a separate power supply with 12 volts and output power 500 mA!
Internal battery pack	Two AA batteries located underneath the box.
DESS key housing	Allows you to program DESS keys.
LED	Indicates that the DESS Post Interface is powered and communication with the MPI-2/MPI-3 interface is established.

 

 

 

 

 

 

 

 

 

 

 

 

Software

The DESS Post Interface contains identification parameters.  Upon startup, B.U.D.S. reads these parameters and displays them into the MPI Information window.

[Author]

Posts